Published Papers

ABSTRACT: There are two basic methods of calibrating a transmission sphere without use of an external artifact, statistical or shear. In the low NA range where shearing is the preferred method, the calibration is difficult to perform precisely because it is hard to measure the shear distance or rotation of the reference surface precisely. If the reference is a Fresnel zone CGH, then there are two centers of curvature that provide an axis that can be located precisely. We show theoretically and experimentally an absolute method of calibrating a TS using one rotational and one translational shear.

ABSTRACT: Talk is largely tutorial by has a two-fold motivation Definitions of kinds of alignmentInitial alignment steps to get light into alignment sensor-autostigmatic microscope, alignment telescope or interferometer Systematic alignment steps using the alignment sensor. Good idea to have a written procedure because many steps Alignment results using real hardware. Robert E. Parks, Benjamin F. […]

Robert E. ParksOptical Perspectives Group, LLC Tucson, AZ 85750 Daewook KimJ. C. Wyant College of Optical Sciences The University of Arizona Tucson, AZ 75721 INTRODUCTION Following the discovery of so called non- diffracting Bessel beams [1], they have been used for a number of exotic purposes such as trapping single atoms and aiding in the […]

Robert E. Parks and William P. KuhnOptical Perspectives Group, LLC, 9181 E. Ocotillo Drive, Tucson, AZ 85749 ABSTRACT We give an example of a Point Source Microscope (PSM) and describe its uses as an aid in the alignment of optical systems including the referencing of optical to mechanical datums. The PSM is a small package […]

From the beginning we have said that centering a lens meant aligning the optical axis of the lens to a reference axis. Up to this point we have assumed the axis was the mechanical axis of a rotary table. Because there are disadvantages to using a rotary table, I was curious to see if there […]

A convenient and concrete example of aligning three centers of curvature is the cementing of the doublet we used in the optical axis example in Chapter 5, the details of which are reproduced below. Fig. 1 Doublet used as an example of aligning three centers of curvature The goal is to get all three centers […]